Works flawless, tail is locked in, perfect upgrade.
Had issues with my tail blowing out on my 470L. This tail pulley and belt was the perfect solution, no more tail blow outs, lower gain on gyro. And Amazed by the quality of the printed gear. I will continue to support KC3D!
The teeth on the gear is not deep enough so no matter how tight you make your belt it's still slips I have it tighter than I've ever had it before and the belt slips around the gear contact is my body and then you want to talk to you like you're stupid So now I'm leaving a review for the gear that is a waste of money your mouth is still with a slight tail blowout
Many charging options out there. Ordering from KC3D JUNK DRAWER was the best decision I’ve made. Glad I waited. Keith is on point from start to finish.
Whatever your tool ecosystem (I prefer Makita green), get a battery adapter for your Sullivan starter. The product is rugged and easy to install (no soldering needed)! The battery attaches firmly on the back end of the starter. This gives the starter system better balance, especially when used vertically for helis. It looks a lot better, than having a LiPo hanging off the side, too. Works great on your Sullivan Dynatron or Hi-Tork starter.
I wanted to wait until after a good test drive. These skid clamps held perfectly. 4+ hours on NC roads plenty of pot holes, bumps, dips and poor drivers. These skid clamps held 2 700s, 600 and a 380 without fail in my trailer. I recommend these skid clamps to anyone with 100% confidence. Will order more without hesitation. Thank you KC3D Print.
Lou (FlyRightRc@Youtube)