KC3D LLC
Sullivan Dynatron Makita 18V Battery Adapter
Sullivan Dynatron Makita 18V Battery Adapter
For installation instructions, click here.
If you use Makita 18V power tools you already have the perfect battery to power your Sullivan Dynatron starter. The Makita batteries are 5s2p LiIon batteries with built in protection circuits for overcurrent and overdischarge. The Dynatron will turn over a 1.20 nitro engine with ease on the 18V nominal Makita batteries.
This 3D printed adapter mounts to the Dynatron motor and provides an easy way to use your Makita 18V batteries for a convenient starter setup. It balances well in the hand and doesn't add a ton of bulk to your starter (depending on the battery size you use). Comes partially assembled and pre-wired. Wago 221-412 wire splicing terminals make it easy to connect your Dynatron's input leads to the adapter and get flying with no soldering required.
The adapter pieces also have holes into which you can put the disassembled Sullivan wand, to save on travel space. Other wands between 7-8mm in diameter will fit, though not all will reach into the rear retainer.
This product includes:
1 x 3D Printed Sullivan Dynatron Makita 18V Mount Set (Black ABS Plastic)
1 x Injection Molded Makita 18V Battery Terminal w/ Wiring
This product has a limited lifetime warranty. If the 3D printed pieces break due to impact damage, let us know and we'll get a new one sent out to you. The warranty does not cover melted or damaged wiring or terminal due to extended periods of too high amp draw (e.g. stalling the starter motor for too long).
Makita Battery, Charger, and Dynatron not included.
Shipping Disclaimer:
In an effort to reduce waste of shipping supplies, if you order only a starter adapter, it will ship in the single box that it is packaged in instead of being double boxed. Any additional small items ordered, if they can fit into the adapter box itself that is how it will ship. If your order is too much to fit into the starter adapter box, then it will be double boxed.
Share
Fast service. Great product.
Really good.
Sullivan Dynatron Makita 18V Battery Adapter
I am really glad I ordered the Makita battery adapter, its a lot less bulky than adding a lipo, and I already have the Makita batteries at home!
10/10, I would order again
Whatever your tool ecosystem (I prefer Makita green), get a battery adapter for your Sullivan starter. The product is rugged and easy to install (no soldering needed)! The battery attaches firmly on the back end of the starter. This gives the starter system better balance, especially when used vertically for helis. It looks a lot better, than having a LiPo hanging off the side, too. Works great on your Sullivan Dynatron or Hi-Tork starter.