These clips will help you make your wiring and plumbing neat and tidy. The inner diameter is ~1/4" (6.35mm) meaning you can fit most fuel tubing, electronic ignition cables, battery leads, or small bundles of servo wires inside.
Printed in a stiffer than typical TPU filament for strong grip and has a recessed M2 size screw hole for attaching to the airframe. Can also be glued with pretty much any adhesive (CA recommended) if you're unable to use screws in your application.
Single Just a basic single 1/4" clip. Screws down from the top with a M2 screw. Good for just about everything.
Dual Two single clips next to each other. Good for battery cables and parallel wiring/tubing runs.
Flat Single clip with flat mounting on its side. Good for passing wiring/tubing through holes.
This product is always made to order, so lead-time before shipment may be as long as a week.
